All protocols
Sexual Health / Fertility

PT-141 (Bremelanotide) Peptide Protocol & Dosing

Updated 2mo ago 8 min read 421+ helpful Calculator
Validity Score

Validity Score

77 Strong
Evidence 80
Community 70
Completeness 71
Actionability 80
Coverage 80
Penalty -0

This score combines formal evidence, page completeness, calculator readiness, and community convergence.

What it is

PT-141 (bremelanotide) is a centrally acting melanocortin receptor agonist with a licensed human indication for hypoactive sexual desire disorder. It works through the brain rather than the peripheral vascular pathway.

Evidence boundary

Human evidence and a licensed indication exist. Keep the interpretation close to the labeled PRN use case.

Trial evidence

  • PMID 36242769 — An evaluation of bremelanotide injection for the treatment of hypoactive sexual desire disorder.
  • PMID 38767282 — Pharmacotherapy of Hypoactive Sexual Desire Disorder in Premenopausal Women.
  • PMID 41419078 — Strategies for Treating Sexual Health Concerns After Breast and Gynecologic Cancer.

Preparation and measurement

Reconstitution: 10 mg vial + 2 mL BAC = 5 mg/mL.

Concentration matches.

Reference schedule

Reference schedule
PhaseDoseDraw / measureFrequencyWeekly total
Initial tolerance exposure500 mcg10 U (0.1 mL)Single PRN doseNot fixed
Typical PRN range1–1.75 mg20–35 U (0.2–0.35 mL)As needed; no more than once per 24 hoursNot fixed

Initial tolerance exposure

Dose
500 mcg
Draw / measure
10 U (0.1 mL)
Frequency
Single PRN dose
Weekly total
Not fixed

Typical PRN range

Dose
1–1.75 mg
Draw / measure
20–35 U (0.2–0.35 mL)
Frequency
As needed; no more than once per 24 hours
Weekly total
Not fixed

Weekly totals do not apply here. This is on-demand use, not a daily schedule.

Titration rules

  • This is an on-demand protocol, not a daily escalation.
  • Start with the lower single dose before moving up.
  • Do not exceed one administration in 24 hours.
  • Keep the lowest effective PRN dose.

Cycle length and breaks

Use is PRN and assessed after each dose.

What to monitor

  • Desired sexual-response effect
  • Nausea, flushing, headache
  • Transient hypotension

Practical rules

  • Inject 30–45 minutes before the desired effect.
  • Keep a firm 24-hour minimum between doses.
  • Consider an antiemetic if nausea is a problem.
  • Rotate sites if dosing sub-Q.
Was this protocol helpful?
Share via

Dosing Calculator

10 mg + 2 mL BAC · week 1 500 mcg
LIVE CALCULATIONvolume / concentration / draw
RP–CALC–01
DRAW AMOUNT10 units0.1 mL · U-100
Draw 10 units, equivalent to 0.1 milliliters.
Concentration5 mg/mL
Selected dose0.5 mg (500 mcg) = 10 units
Enter a desired amount in milligrams or micrograms.
05 Standard amounts
1–10 mg · 0.5 mg steps
06 Suggested doses Select a row
1 unit = 0.01 mL on a U-100 syringe. Values retain decimal precision; visual marks are not silently snapped.
07 cycle summary

Vials required for Cycle

Estimate how much material you need for a full cycle, including cycle length and the number of cycles you plan to run.

Cycle total —
Total required vials —
Total reconstitution —
Total BAC water —
08 projected levels

How the draws stack up

A first-order model of depot absorption and elimination, run on the draws and cadence above. Pick the half-life from whatever your own source documents — this page does not assume one per compound. A planning sketch — not a prediction for any compound or any individual.

Half-life

Modelled level across the cycle. Each spike is one draw.

Accumulation—steady state vs one draw
Peak-to-trough—inside one interval
Steady state—about 4 half-lives
Draws modelled—at this cadence
Vial yieldat the selected amount
Draws per vial—
Lasts—
Volume used—
Limiting factor—
Water matrixsame vial, same amount
WaterStrengthDraw
0.5 mL——
1 mL——
2 mL——
3 mL——
5 mL——

Research Protocols

Keep up to date with latest protocols, updates and offers

An occasional email when a new protocol lands or an existing one is revised. No more than once a month.